Filter
Top Products
18
5.1.2 Preparing for TG-2000A setup
Preparing for installation
Before installing the TG-2000A application, do the following checks and preparatory steps.
Steps Action Details How to
1 Check the OS Check the OS Service Pack version.
• Windows Vista
® Business:
Service Pack 1
• Windows
® XP Professional:
Service Pack 3
• Windows
® 2000 Professional:
Service Pack 4
*Only English version
*Use TG-2000A Ver.5.1* for Windows® 2000
Professional.
* Change if the OS differs
from the applicable OS.
2 Check the memory Check the requirement of the memory
capacity for OS used.
・Windows Vista : 1GB or more
・Windows XP/2000 : 512MB or more
* Install expansion memory
if required.
3 Check the HDD free
space
Check that there is at least 2GB of free
space on the C drive. (OS already set
up)
*Refer to section 2.1 when using the
trend or the wide area function.
* Refer to the Windows
instruction manual for
more details.
4 Printer settings *1 Install the printer driver and check that
printing is possible.
* For details, refer to the
attached instruction
manual.
5 Set the date and time In the Windows Control Panel, select
“Date and Time” and set the date, time
and region
*Set the region to English.
*Use "." for a decimal point, and "," for a
delimiter.
* For details, refer to the
Windows users manual.
6 Screen size and color
settings
At the “display” in the Windows Control
Panel, set the screen size to 1024 × 768
or larger and the color to 65536 colors
(High Color (16-bit)) or more.
* For details, refer to the
Windows users manual.
7 Automatic login
settings
Check that the Auto log-in is set. *2
* For the setting check pro-
cedure, see Appendix 2 Auto
Log-in Check Procedure.
8 Network settings Check that the network settings have
been performed (even if the adapter is
not connected).
* For details, refer to the
Windows users manual.
9 Check the power
option settings
Check that the settings for the "System
standby" and "System hibernates" are set to
"OFF" in the power option's "Power settings".
* For details, refer to the
Windows users manual.
*1 Check when using the printer.
*2 Auto log-in sets the automatic start-up without entering the log-in name or password at the
Windows(OS) start-up.
*3 Set the integrated centralized control software TG-2000A so it can be used 24-hours.
Note:
• Unless the Auto log-in is set up, TG-2000A will not start up when the PC is rebooted after the
TG-2000A has restarted itself. Be sure to set up the Auto log-in.
• Do not change the computer name after the TG-2000A has been setup. TG-2000A will not run
properly if changed, and may require the Windows(OS) to be installed again.
Note:
• The AG-150A- and G-50A-compatible TG-2000A must be used to Ver. 5.5* or later. These
versions of the TG-2000A run on Windows Vista or Windows XP.
• To use the functions supported by older versions of G-50A-compatible TG-2000A, use TG-2000A
Ver. 5.1* This version runs on Windows XP or Windows 2000.