Filter
Top Products
38
All setting transmission window
6.2 Basic Mouse Operation
First, use of the mouse as a pointing device will be explained. If a device other than a mouse is being
used, consult with the manual for that device.
The following is a list of terms used in describing mouse operations.
Click : This refers to pressing and releasing the button one time.
To use this function, click the button
Double Click : This refers to pressing and releasing the button twice in quick succession.
Drag : This refers to moving the mouse pointer on top of an object on the screen, pressing
and holding down the button to select the object, then, while holding the button down,
moving the mouse pointer, and the object, to a different location.
Keyboard : Primarily used when entering password, characters, or numerics.
6.3 Accessing Functions and Moving between Windows
The functions of the TG-2000A can be divided into two general categories.
1) Functions that monitor air conditioner operation status and control functions……Control window
2) Operation and system initialization and charge data maintenance functions (functions used to
accomplish functions in 1) above) ……Initial window
This section deals mostly with functions in category 2).
(1) Shift from the initial window to the control window
The following shows the procedure to shift from the initial window to the control window. Shift the
screen to the control window after completing the initial setting shown in Chapter 8.
During normal operation
Only the changed settings are transmitted to the
AG-150A/G-50A.
Normally shift to the control window using this method.
[Procedure]
1) Select [Finish] button.
Click the [Finish] button located on the lower right on the initial screen. With the above step, the
confirmation screen (asking whether or not to trans-
mit the setting contents to the AG-150A/G-50A) is
displayed.
2) Select [OK] button.
Click the [OK] button to transmit the initial setting
contents to the AG-150A/G-50A.
* Click the [Cancel] button to return to the Initial window.
The start-up display screen is displayed after the
screen has been shifted to the control window. The
system information set or changed is transmitted to
each G-50A to enter upon the start-up processing.
It takes approximately 1 to 20 minutes
to start-up.
To transmit all settings
All of the settings are transmitted to the
AG-150A/G-50A.
Use this method to shift to the control window
when there is a difference in the system
information after starting up, or when copying a
set database to the site.
[Procedure]
1) Select [Configuration] - [All setting transmission]
in the menu bar.
Click the [Setting] in the menu bar on the control window to select [All setting transmission].
A screen for confirming whether to transmit all settings to the AG-150A/G-50A is displayed.
Screen of confirmation fo
r
transmitting set contents
Start -up display screen