Filter
Top Products
5. PARAMETERS
5 - 44
No. Symbol Name and function
Initial
value
[unit]
Setting
range
PD11 *DIF Input filter setting
Select the input filter.
Refer to the
"Name and
function" column.
Setting
digit
Explanation
Initial
value
_ _ _ x Input signal filter selection
Refer to the servo system controller instruction manual for the
setting.
If external input signal causes chattering due to noise, etc., input
filter is used to suppress it.
0: None
1: 0.888 [ms]
2: 1.777 [ms]
3: 2.666 [ms]
4: 3.555 [ms]
4h
_ _ x _ For manufacturer setting 0h
_ x _ _ 0h
x _ _ _ 0h
PD12 *DOP1 Function selection D-1 Refer to the
"Name and
function" column.
Setting
digit
Explanation
Initial
value
_ _ _ x For manufacturer setting 0h
_ _ x _ 0h
_ x _ _ 0h
x _ _ _ Servo motor or linear servo motor thermistor enabled/disabled
selection
0: Enabled
1: Disabled
For servo motors or linear servo motor without thermistor, the
setting will be disabled.
This parameter setting is used with servo amplifier with software
version A5 or later.
0h
PD13 *DOP2 Function selection D-2
Select the INP (In-position) on condition.
This parameter is supported with software version B4 or later.
Refer to the
"Name and
function" column.
Setting
digit
Explanation
Initial
value
_ _ _ x For manufacturer setting 0h
_ _ x _ 0h
_ x _ _ INP (In-position) on condition selection
Select a condition that INP (In-position) is turned on.
0: Droop pulses are within the in-position range.
1: The command pulse frequency is 0, and droop pulses are within
the in-position range.
When the position command is not inputted for about 1 ms, the
command pulse frequency is decided as 0.
0h
x _ _ _ For manufacturer setting 0h