Filter
Top Products
Bosch Security Systems | 2011-02
Praesideo 3.5 | Installation and User Instructions | 11 | Optional Software en | 475
60.6 User Interface
60.6.1 Overview
The PC Call Station Client screen is divided in four areas
(panes):
1 Call/BGM selection pane - A pane that allows
you to select predefined calls or BGM channels.
There are two tabs in this pane, one for selection of
Predefined calls and one for selection and control of
BGM channels.
2 Zone selection pane - A pane that allows you to
select zones and zone groups. It shows the status of
the zones and zone groups using icon
representations.
3 Control pane - A pane that allows you to control
the predefined call or BGM channel that you
selected from the Call/BGM selection pane.
4 Status bar - Shows the status of the PC Call Station
Client.
60.6.2 Make a call
Use the following procedure to make a call:
1Select tab Predefined to get a list of predefined calls
for this user.
2 Select a predefined call from this list in the call
selection pane.
3 Optionally add zones to or remove zones from the
selection in the zone selection pane. The selection
may also contain zone groups.
4 Start the call with the Start button in the control
pane. The button changes into a stop button so that
the call can be stopped. While the call runs, its
progress is shown in the progress bar in the control
pane: start tone, message(s), live speech and end
tone. A predefined call does not need to contain all
of these elements.
5 Stop the call. A call without live speech will finish
even if not stopped.
6 If the button has been configured for abort on repress
operation, it is possible to abort the call now. The
difference between stopping and aborting a call is
that a running message or tone is completed before a
call stops while it is aborted immediately in case a
call aborts.
The status bar may show a warning to the user in case of
licensing/dongle problems. Optionally, depending on
the user configuration, the list of predefined calls also
contains a button to acknowledge and subsequently
reset an emergency state.
60.6.2.1 Predefined call selection buttons
Note
When the
PC Call Station Client
becomes
disconnected from the
PC Call Server,
a new
login is required after fixing the problem.
But when the
PC Call Station Client
starts up
while it is disconnected from the
PC Call Server
(e.g. the network cable was disconnected or its
network switch was powered off), a warning is
given. After fixing the problem, the
PC Call
Station Client
must be closed now and restarted
in order to reconnect; there was not yet a remote
connection established that can be restored.
figure 60.2: Predefined calls tab
figure 60.3: Selection buttons