Filter
Top Products
Bosch Security Systems | 2011-02
Praesideo 3.5 | Installation and User Instructions | 9 | System Configuration en | 352
43.4 Call station
43.4.1 Procedure
Proceed as follows to configure a call station:
1Go to Configure > Equipment configuration > Call
station. A screen similar to the one in figure 43.20
appears in the main frame of the web interface.
2 Click the name of the call station that must be
configured. A screen similar the one in figure 43.3
appears in the main frame of the web interface.
3Open the General category to configure the general
settings of the call station.
• See section 43.4.2 for information about
configuring the general settings of a basic call
station (LBB4430/00)
• See section 43.4.3 for information about
configuring the general settings of a call station
kit (LBB4433/00).
• See section 43.4.4 for information about
configuring the general settings of a remote call
station (PRS-CSR) or remote call station kit
(PRS-CSRK).
4 Open the Audio Inputs category to configure the
audio inputs of the call station (see section 43.4.5).
5 When the call station has a numeric keypad, open
the Numeric keypad category to configure the numeric
keypad (see section 43.4.6).
6 When the call station has control inputs, open the
Control Inputs category to configure the control inputs
(see section 43.4.7). If the call station is a remote call
station or a remote call station kit, there is also a
category for configuring the control inputs of the call
station interface.
7 Open the Keypad categories to configure the keypads
connected to the call station (see
section 43.4.8).
8 Submit the changes. Note that the changes are not
permanent until the configuration is saved (see
section 40.4.4 and section 40.4.5).
figure 43.20: Configure call station, step 1
figure 43.21: Configure call station, step 2
Note
The system definition of the call station (see
42.5) determines whether a numeric keypad
category and/or keypad categories are available.