Filter
Top Products
Bosch Security Systems | 2011-02
Praesideo 3.5 | Installation and User Instructions | 8 | Software en | 312
36.2.2 Praesideo core software
The Praesideo core software consists of the File Transfer
Application and all files that must be transferred to the
network controller and other units in the system.
Proceed as follows:
1 Start the PRS-SW Praesideo Software DVD (see
section 35.2). A screen similar to the one in figure
35.1 appears.
2Go to Mandatory > Praesideo core x.yy.zzzz (where x.yy
is software release number and zzzz is the build
number). A File Download window appears.
3 Click the Run button to start the Praesideo core
software setup program.
4 Follow the instructions that are displayed on screen.
A notification is displayed when the installation is
finished.
36.2.3 SVG viewer
The SVG viewer must be installed on the configuration
PC to be able to operate the audio processing part of the
web interface. Proceed as follows:
1 Start the PRS-SW Praesideo Software DVD (see
section 35.2). A screen similar to the one in figure
35.1 appears.
2Go to Mandatory > SVG viewer. A File Download
window appears.
3 Click the Open button to start the SVG viewer setup
program. Follow the instructions that are displayed
on screen. A notification is displayed when the
installation is finished.
36.3 Establishing connection
After the mandatory software has been installed on the
configuration PC (see section 36.2), the configuration
PC must establish a connection with the network
controller to be able to transfer the system files to the
network controller and other units in the system (see
section 36.4). Proceed as follows:
1 If the network controller is connected to an existing
Ethernet, ask the network administrator for:
• An IP address for the network controller.
• A suitable subnet mask.
• The IP address of the default gateway for the
network controller.
2 Go to screen 2Ba of the menu display of the network
controller to set the IP address of the network
controller. See section 5.5 for the configuration
menu.
3 Go to screen 2Bb of the menu display of the network
controller to set the subnet mask of the network
controller.
4 Go to screen 2Bc of the menu display of the network
controller to set the default gateway for the network
controller.
5 Connect the network controller to an existing
Ethernet network or directly to the configuration PC.
6 On the configuration PC, go to Start > Run and enter
cmd to open a command prompt window.
7 Ping the network controller. For example, if the IP
address of the network controller is 192.168.0.15,
enter ping 192.168.0.15.
• If no connection is possible, a screen similar to
the one in figure 36.2 appears.
• If a connection can be established, a screen
similar to the one in figure 36.3 appears.
figure 36.2: Incorrect communication
Microsoft Windows 2000 [Version 5.00.2195]
(C) Copyright 1985-2000 Microsoft Corp.
C:\>ping 192.168.0.15
Pinging 192.168.0.15 with 32 bytes of data:
Request timed out
Request timed out
Request timed out
Request timed out
Ping statistics for 192.168.0.15:
Packets: Sent = 4, Received = 0, Loss = 4 (100% loss)
Approximate round trip in milli-seconds:
Minimum = 0 ms, Maximum = 0 ms, Average = 0 ms