Filter
Top Products
Bosch Security Systems | 2011-02
Praesideo 3.5 | Installation and User Instructions | 9 | System Configuration en | 382
5 Configure the contents of the call macro:
• Select the priority of the call macro from the
Priority list.
• Select the routing scheme of the call macro from
the
Routing Scheme list (see section 3.2.4 for more
information). If the routing scheme is set to
Stacked, the Time out (min.) and Forward on release
of controls appear. Time out sets the maximum
time the call will be kept in memory for later
broadcast. After this time it is deleted.
Forward on
release of gives the option to select whether a
stacked call is forwarded to each zone individually
when it is available again, or to all remaining
zones at once.
• If the call must use a start tone, select a tone from
the Start tone dropdown list. See appendix A for a
list of available tones and chimes. Adjust the
attenuation to set the volume of the tone.
• If the call must contain recorded messages, select
them in the left box and click the > button to add
them to the Messages box of the call macro. Use
the Repetitions box to specify how many times the
recorded messages must be repeated. See
section 44.2 for information about recorded
messages. Adjust the attenuation to set the
volume of the messages.
• If the call must contain live speech, set the Live
speech option to Yes. If the call does not contain
live speech, set it to No. Adjust the attenuation to
set the volume of the live speech.
• If the call must use an end tone, select a tone
from the End tone dropdown list. See appendix A
for a list of available tones and chimes. Adjust the
attenuation to set the volume of the tone.
•If Live speech is set to Yes, use the Audio input list to
specify the input that must be inserted. Select
Default if the live speech is originating from a call
station.
•If Schedule is set to Enabled, call scheduling is
enabled. Enter the start time of the first call in the
Start time field and the interval period in the
Interval field. After the End time, the call will not
be repeated. Specify also the days on which the
call scheduling is active.
•If Live speech is set to Yes, use the Timing scheme list
to specify the timing scheme of the call (see sec-
tion 3.2.5).
• The timing scheme can be used to select Immedi-
ate broadcast of a call. If a call stacker is included
in the system, and Live speech is set to Yes,
Time-shifted broadcast or time-shifted with
Pre-monitor is also possible. A time-shifted call is
broadcast upon completion of the original call or
after the local pre-monitor phase has finished.
• The maximum duration of a call can be config-
ured by selecting one of the following options
from the Maximum call duration droplist: 10 s, 20 s,
40 s, 1 min, 2 min, 5 min, 10 min, 20 min, 30 min
and Unlimited (default).
A maximum call duration avoids blocking of
zones by a high priority call that was started but
not stopped, either by accident or because it con-
tains e.g. infinitely looping messages.
figure 46.5: Add call macro, step 4
Note
When Live speech is set to Yes , call scheduling
is not possible and the fields for call scheduling
are not visible. When Live speech is set to No
the timing scheme is fixed to Immediate.
Note
Do not limit the Maximum call duration when the
Routing scheme is set to Stacked or when the
Schedule is enabled.