Bosch Appliances 3.5 Home Security System User Manual


 
Bosch Security Systems | 2011-02
Praesideo 3.5 | Installation and User Instructions | 10 | Events en | 432
Event message:
SCB failure / Supervision Control Board failure
Originator:
The multi channel interface or the power amplifier
output in which the fault occurred.
Extra information:
----
Description:
Logs the failure of a supervision control board, that is
part of a multi channel interface or that is mounted in a
power amplifier.
Resolve:
When the fault is no longer present and the unit has
been switched off and on again.
Recommended action:
Replace the failing supervision control board of the
power amplifier channel or replace the multi channel
interface.
Event message:
Unit missing
Originator:
Unit that is missing
Extra information:
The network controller detects missing units within 1
minute and missing Open Interface clients within 10
minutes.
Description:
Logs the absence of a configured unit.
Resolve:
When the unit reconnects.
Recommended action:
Disable the configured unit with the configuration
software or connect the missing unit to the system.
Event message:
Unit not configured
Originator:
Unit that is not configured.
Extra information:
This fault event cannot be generated by open
interface clients.
Description:
Logs the connection of a unit that is not configured.
Resolve:
When the unit disconnects.
Recommended action:
Check the serial number and type of the unit that
generated the event. Use the configuration software
to configure and enable the unit.
Event message:
Unknown unit type
Originator:
Unit that was not recognized by the network
controller.
Extra information:
This fault event cannot be generated by open
interface clients.
Description:
Logs the connection of a unit of an unknown type.
Resolve:
When the unit disconnects.
Recommended action:
If the unit is not needed, disconnect it from the
system. If the unit is needed, upgrade to a software
version that supports the unit type. If the current
software version supports the unit type, the unit is
broken and must be repaired.