Filter
Top Products
Bosch Security Systems | 2011-02
Praesideo 3.5 | Installation and User Instructions | 9 | System Configuration en | 374
45.2.2 Overview
The Zone configuration page (see figure 45.2) contains the
following:
• Name - Shows the name of the zone
• Available outputs - Shows the available audio and
control outputs. Use the dropdown list to choose the
types of outputs that are shown.
• Assigned outputs - Shows the outputs assigned to
the zone shown in (1).
• Add/Remove buttons - Using the > and <
buttons, selected outputs can be added to or
removed from Assigned outputs.
• Volume settings - Open the Volume settings
category to configure the volume settings of the zone
(see section 45.2.4).
• AVC settings- Open the AVC settings category to
configure the AVC settings of the zone (see chapter
49).
• Add - Using this button a new zone can be added to
the system configuration.
• Delete - Using this button an existing zone can be
deleted from the system configuration.
• Submit - Using this button changes are submitted to
the network controller.
• Rename - Using this button an existing zone can be
renamed. Automatically this name is replaced
everywhere in the configuration where this zone is
used.
45.2.3 Create a zone
Proceed as follows to create a new zone:
1Go to Configure > Zone & amplifier > Zone
configuration. A screen similar to the one in
figure 45.3 appears in the main frame of the web
interface.
2 Click the Add button and enter a name for the new
zone in the textbox at the bottom of the page. For
example, Departure 2 (see figure 45.4). It may consist
of up to 16 characters.
figure 45.2: Zone configuration, overview
Note
A zone can contain audio outputs as well as
control outputs.
A zone cannot be empty, but e.g. even a single
control output assigned to a zone is a valid
configuration.
Audio output names and control output names
between brackets indicate that these outputs
are not yet enabled in the configuration.
Disabled outputs can be assigned but will not
work.
Note
A zone with only a control output assigned to it
allows a call to activate an external alarm (e.g. a
siren) in a zone.
figure 45.3: Add zone, step 1