Filter
Top Products
Bosch Security Systems | 2011-02
Praesideo 3.5 | Installation and User Instructions | 9 | System Configuration en | 361
43.6 Fiber interface
43.6.1 Procedure
Proceed as follows to configure a fiber interface:
1Go to Configure > Equipment configuration > Fiber
interface. A screen similar to the one in figure 43.31
appears in the main frame of the web interface.
2 Click the name of the fiber interface that must be
configured. A screen similar the one in figure 43.32
appears in the main frame of the web interface.
3 Configure the control inputs of the fiber interface
(see section 43.6.2).
4 Submit the changes. Note that the changes are not
permanent until the configuration is saved (see
section 40.4.4 and 40.4.5).
43.6.2 Control inputs
The configuration page for fiber interface control inputs
is similar to the configuration page for network
controller control inputs (see section 43.2.5).
43.7 CobraNet interface
Proceed as follows to configure a CobraNet interface:
1Go to Configure > Equipment configuration > CobraNet
interface. A screen similar to the one in figure 43.33
appears in the main frame of the web interface.
2 Click the name of the CobraNet interface that must
be configured. A screen similar to the one in
figure 43.34 appears in the main frame of the web
interface.
3 Open the Audio inputs category to configure the
audio inputs of the CobraNet interface (see
section 43.7.1).
4 Open the Audio outputs category to configure the
audio outputs of the CobraNet interface (see
section 43.7.2).
5 Open the Control inputs category to configure the
control inputs of the CobraNet interface (see
section 43.7.3).
figure 43.31: Configure fiber interface step 1
figure 43.32: Configure fiber interface, step 2
figure 43.33: Configure CobraNet interface step 1
figure 43.34: Configure CobraNet interface step 2