Filter
Top Products
Bosch Security Systems | 2011-02
Praesideo 3.5 | Installation and User Instructions | 9 | System Configuration en | 340
8 Submit the changes. Note that the changes are not
permanent until the configuration is saved
(see section 40.4.4 and section 40.4.5).
43.2.2 General
figure 43.4: Configure network controller, step 3
5 6
3
4
table 43.1: General configuration
Item Value Description
Mains power
supervision
On
Off
Specifies whether the mains power must be supervised.
When Mains power supervision is On and the mains
power is failing, a fault event is generated. Setting Mains
Power Supervision to Off when mains power is used,
results in a system that does not detect mains power
failures.
Back-up power
supervision
On
Off
Specifies whether the back-up power must be supervised.
When Back-up power supervision is On and the back-up
power is failing, a fault event is generated. Setting
Back-up power supervision to Off when back-up power is
used, results in a system that does not detect back-up
power failures.