Filter
Top Products
Bosch Security Systems | 2011-02
Praesideo 3.5 | Installation and User Instructions | 9 | System Configuration en | 363
43.8 Multi Channel Interface
43.8.1 Procedure
This section describes the configuration of a multi
channel interface. The basic amplifiers, which are
connected to the multi channel interface, are not
configured directly by the configuration web pages, but
via the multi channel interface.
Configure the multi channel interface and connected
basic amplifiers as follows:
1Go to Configure > Equipment configuration > Multi ch
interface. A screen similar to the one in figure 43.39
appears in the main frame of the web interface.
2 Click the name of the multi channel interface to be
configured. A screen similar to the one in figure
43.40 appears in the main frame of the web interface
3Open the Audio Outputs category to configure the 14
main outputs of the multi channel interface. (See
section 43.8.2.)
4Open the Spare Outputs category to configure the 2
spare outputs of the multi channel interface. (See
section).
5 Open the Control Inputs category to configure the 32
control inputs of the multi channel interface. (See
section 43.8.4.
6 Open Control Outputs category to configure the 16
control outputs of the multi channel interface. (See
section 43.8.5.
7 Submit the changes. Note that the changes are not
permanent until the configuration is saved (see
section 40.4.4 and section 40.4.5).
figure 43.39: Configure multi channel interface, step 1
figure 43.40: Configure multi channel interface, step 2