Filter
Top Products
Bosch Security Systems | 2011-02
Praesideo 3.5 | Installation and User Instructions | 9 | System Configuration en | 332
The hexadecimal serial number of a unit consists of 8
digits ranging from 0 to F. The combination of the first
and second digit identifies the type of unit.
42.3 Network controller
Proceed as follows to register the network controller:
1Go to Configure > System definition > Network controller.
A screen similar to the one in figure 42.3 appears in
the main frame of the web interface.
2 Enter a name for the network controller in the Name
field.
3 Enter the hexadecimal serial number of the network
controller in the Serial number field.
4 When the network controller is physically present, it
can be enabled by ticking the Enabled checkbox.
5 Submit the changes. Note that the changes are not
permanent until the configuration is saved. (see
section 40.4.4 and section 40.4.5).
table 42.1: Serial number ranges (addressable units)
Type no . Description ID
PRS-NCO-B Network Controller 11
PRS-16MCI Multi Channel Interface 1B
LBB4402/00 Audio Expander 12
LBB4404/00 CobraNet Interface 1C
PRS-NSP Network Splitter 14
PRS-FIN(S)
PRS-FINNA
Fiber Interface 15
PRS-1P500
PRS-2P250
PRS-4P125
LBB4428/00
Power Amp. 1 x 500 W
Power Amp. 2 x 250 W
Power Amp. 4 x 125 W
Power Amp. 8 x 60 W
0B
0A
09
08
LBB4430/00
LBB4433/00
Call Station Basic
Call Station Kit
0C
0E
PRS-CSI Remote Call Station
(Call Station Interface)
1D
PRS-CRF Call Stacker 1F
Note
If the real serial number is not (yet) known, the
temporary serial number 0 can be used for all
units. In this way, most of the configuration can
be done off-line already. Communication with
actual units in the system is only possible when
the temporary serial numbers have been
replaced by the real serial numbers. Units in the
configuration with the serial number 0 are
ignored by the actual system in operation.
figure 42.3: Register network controller, step 1
Note
The name is also shown on the display of the
network controller.
Note
The serial number itself is not checked.
However, the software checks that all entered
characters are hexadecimal characters and that
the serial number is 8 characters long or is 0.