Filter
Top Products
Bosch Security Systems | 2011-02
Praesideo 3.5 | Installation and User Instructions | 9 | System Configuration en | 339
43 Equipment configuration
43.1 Introduction
On the Equipment configuration pages, each piece of
equipment that has been added using the System
definition pages can be configured. Using the Equipment
configuration pages, it is possible to configure:
• Network controllers (see section 43.2).
• Power amplifiers (see section 43.3).
• Call stations (see section 43.4).
• Audio expanders (section 43.5).
• Fiber interfaces (see section 43.6).
• CobraNet interfaces (see section 43.7).
• Multi Channel Interfaces (see section 43.8).
43.2 Network controller
43.2.1 Procedure
Proceed as follows to configure the network controller:
1Go to Configure > Equipment configuration > Network
controller. A screen similar to the one in figure 43.2
appears in the main frame of the web interface.
2 Click the name of the network controller that must
be configured. A screen similar the one in figure 43.3
appears in the main frame of the web interface.
3 Open the General category to configure the power
supervision settings.
(see section 43.2.2).
4 Open the Audio inputs category to configure the
audio inputs of the network controller
(see section 43.2.3).
5 Open the Audio outputs category to configure the
audio outputs of the network controller
(see section 43.2.4).
6 Open the Control inputs category to configure the
control inputs of the network controller
(see section 43.2.5).
7 Open the Control outputs category to configure the
control outputs of the network controller
(see section 43.2.6).
figure 43.1: Equipment configuration pages
Equipment configuration
Network controller
Power amplifier
Call station
Audio expander
Fibre interface
Cobranet interface
Multi channel interface
figure 43.2: Configure network controller, step 1
figure 43.3: Configure network controller, step 2
5 6
3
4