Filter
Top Products
Bosch Security Systems | 2011-02
Praesideo 3.5 | Installation and User Instructions | 9 | System Configuration en | 368
44 System wide settings
44.1 Introduction
On the System wide settings pages, a number of general,
system wide settings can be configured. It is possible to:
• Register recorded messages (see section 44.2).
• Specify system settings (see section 44.4).
44.2 Recorded messages
44.2.1 Introduction
On the Recorded messages page, WAV files (audio files)
that have been transferred from the configuration PC to
the network controller in the form of a message set, can
be registered. See section 44.3 for information about
creating and transferring messages sets.
44.2.2 Register a recorded message
Proceed as follows to register a recorded message:
1Go to Configure > System wide settings > Recorded
messages. A screen similar to the one in figure 44.2
appears in the main frame of the web interface.
2 Click the Add button to add a recorded message. A
screen similar to the one in figure 44.3 appears in the
main frame of the web interface.
3 Enter the name of the WAV file in the message set in
the Name field (see figure 44.4 for an example).
• The name must be exactly the same as the name
of the WAV file (including upper- and lowercase
characters). It may consist of up to 16 characters.
• The extension .wav must be omitted.
4 Click the OK button to add the recorded message to
the list of registered recorded messages. A screen
similar to the one in figure 44.5 appears in the main
frame of the web interface.
5 Submit the changes. Note that the changes are not
permanent until the configuration is saved (see
section 40.4.4 and 40.4.5).
figure 44.1: System wide settings pages
figure 44.2: Register message, step 1
System wide settings
Recorded messages
System settings
figure 44.3: Register message, step 2
figure 44.4: Register message, step 3
figure 44.5: Register message, step 4