Filter
Top Products
Bosch Security Systems | 2011-02
Praesideo 3.5 | Installation and User Instructions | 10 | Events en | 414
The information about the fault events (see chapter 54)
describes how the fault events are resolved.
51.4.5 Resetting fault events
51.4.5.1 Introduction
Resolved fault events can be reset:
• Using the network controller (see section 51.4.5.2).
• Using control inputs or keys (see section 51.4.5.3).
• Using the open interface (see section 51.4.5.4).
•Using the Logging Viewer (see chapter 57).
51.4.5.2 Network controller
Resolved fault events can be reset using the Faults...
menu of the network controller (see section 5.6.5). Using
this menu it is possible to reset individual fault events as
well as all resolved fault events in the system.
51.4.5.3 Control input or key
Resolved fault events can be reset using control inputs
or keys to which an Acknowledge/Reset action has been
assigned (see section 47.3.23). However, such a control
input or key resets all resolved fault events in the
system. It is not possible to reset individual faults using a
control input or key.
51.4.5.4 Open interface
Resolved fault events can be reset using the open
interface (see the Open Interface Programming
Instructions).
Note
When all faults are reset, the Fault alarm
indicator outputs are deactivated.