Filter
Top Products
Bosch Security Systems | 2011-02
Praesideo 3.5 | Installation and User Instructions | 9 | System Configuration en | 334
4 Click the OK button to add the power amplifier to
the list of power amplifiers in the system. A screen
similar to the one in figure 42.7 appears in the main
frame of the web interface.
5 When the power amplifier is physically present, it
can be enabled by ticking the Enabled checkbox.
6 Submit the changes. Note that the changes are not
permanent until the configuration is saved (see
section 40.4.4 and section 40.4.5).
42.4.2Delete a power amplifier
Proceed as follows to delete a power amplifier from the
system definition:
1Go to Configure > System definition > Power amplifier.
A screen similar to the one in figure 42.8 appears in
the main frame of the web interface.
2 Click anywhere in the row of the power amplifier
that has to be deleted from the system definition.
The entire row is highlighted (see figure 42.9).
3 Click the Delete button. A screen similar to the one in
figure 42.10 appears in the main frame of the web
interface.
4 Click the OK button to delete the power amplifier
from the system definition. A pop-up window asks
for confirmation.
5 Click the OK button to confirm the pop-up message.
A screen similar to the one in figure 42.11 appears in
the main frame of the web interface. The deleted
power amplifier is no longer listed in the table.
figure 42.7: Add power amplifier, step 4
Note
It is not recommended to delete a unit if its
inputs or outputs are being used in for example
the Zone & Amplifier or Action Programming
pages. However, if a unit is deleted, all of its
inputs and outputs will be removed from the
configuration (e.g. from macros and zones).
figure 42.8: Delete power amplifier, step 1
figure 42.9: Delete power amplifier, step 2
figure 42.10: Delete power amplifier, step 3
figure 42.11: Delete power amplifier, step 5