Filter
Top Products
Bosch Security Systems | 2011-02
Praesideo 3.5 | Installation and User Instructions | 3 | Control Equipment en | 103
5.7.8 Audio line inputs 5.7.9 Audio microphone inputs
(only input 1 and input 2)
Connector (rear side):
Female XLR and female stereo cinch socket per input.
The stereo signal from the cinch is internally converted
to a mono signal
Preferred cable:
Shielded
Maximum input signal level:
18 dBV ± 1 dB (XLR)
6 dBV ± 1 dB (cinch)
Input range:
-12 dB to 0 dB with respect to maximum input level
Input sensitivity setting:
Software
Frequency response:
-3 dB points at 20 Hz and 20 kHz (tolerance ± 1 dB)
Input impedance:
100 kohm (XLR)
12 kohm ( cinch )
Signal/Noise ratio:
> 87 dBA at maximum level
Common mode rejection ratio:
> 40 dB
Input cross-talk:
> 75 dB at maximum level at 100 Hz, 1 kHz
and 10 kHz
Distortion:
< 0.05% at 1 kHz at -3 dB of the maximum input level
Connector (rear side):
Female XLR per input
Preferred cable:
Shielded
Nominal input level:
-57 dBV based on 91 dBSPL for a microphone with
sensitivity of 2 mV/Pa, a male voice with normal
loudness and a speaker to microphone distance of
0.15 m
Headroom:
30 dB
Input range:
-7 to +8 dB with respect to nominal input level
(limiter threshold)
Input sensitivity setting:
Software
Frequency response:
-3 dB points at 300 Hz and 20 kHz (tolerance ± 1 dB)
First order, high-pass speech filter at 300 Hz
Input impedance:
136 0 ohm
Signal/Noise ratio:
> 62 dBA with 25 dB headroom
Common mode rejection ratio:
> 55 dB at 100 Hz
> 65 dB at 1 kHz and 10 kHz
Phantom supply:
12 V ± 1 V (max. 15 mA)
Limiter:
Analog limiter, level -8 dB with respect to maximum.
• attack time: 1 ms
• decay time: 300 ms
• threshold at nominal input level
(Only for network controllers of version HW15/xx and
higher. Hardware information can be obtained using
the front panel menu.)