Filter
Top Products
Emerson Process Management GmbH & Co. OHG 9-23
X-STREAM X2
Instruction Manual
HASX2E-IM-HS
02/2012
9
Modbus Commands
9.4 List of Parameters and Registers - Sorted by Registers
Address Tag Name
Data
Type
Client
Access
Description
Daniel Modicon
2033 2033 Control.ApplyGas.PumpState Boolean R/W 0=Off, 1=On
2033 2033 Status.Calibration.PumpState Boolean RO state of built-in pump
2037 2037 Control.ResetDevice Boolean R/W reset the device: 0=none, 1=reset
2038 2038 Control.AcknowledgeStates Boolean R/W 1=Acknowledge device‘s states, 0=no effect
2039 2039 Control.RemoteExclusive Boolean R/W
Device access mode (0=Remote&LOI, 1=Remo-
teOnly)
3001 3001 Service.General.NumberChannels Word R/W number of built-in component channels
3002 3002 Service.General.WarmupTime Word R/W time in secs that is used for warmup phase
3003 3003
Setup.Measurement.Response-
Time1
Word R/W signal damping (in secs) for gas change of comp1
3004 3004
Setup.Measurement.Response-
Time2
Word R/W signal damping (in secs) for gas change of comp2
3005 3005
Setup.Measurement.Response-
Time3
Word R/W signal damping (in secs) for gas change of comp3
3006 3006
Setup.Measurement.Response-
Time4
Word R/W signal damping (in secs) for gas change of comp4
3007 3007 Service.Linearizer.Unlinear Word R/W
activates unlinear concentration measurement (0
= no, 1 = yes)
3008 3008 Service.RemoteSecurity Word R/W Input Code to enable service accesss
3011 3011
Service.Measurement.MaxConce-
Percent1
Word R/W
max. allowed values in % of range for cal gases
and conc limits
3012 3012
Service.Measurement.MaxConce-
Percent2
Word R/W
max. allowed values in % of range for cal gases
and conc limits
3013 3013
Service.Measurement.MaxConce-
Percent3
Word R/W
max. allowed values in % of range for cal gases
and conc limits
3014 3014
Service.Measurement.MaxConce-
Percent4
Word R/W
max. allowed values in % of range for cal gases
and conc limits
3015 3015
Service.Measurement.Difference-
Measurement
Word R/W
biteld to enable difference mode (b0=Ch1,
b1=Ch2 etc.)
3016 3016
Setup.In/Outputs.AnalogOut.
AOutType
Word R/W
AOut behavior (0=0_20,1=4_20,2=0_20L,3=4_20
L,4=0_20H,5=4_20H)
3017 3017
Setup.In/Outputs.AnalogOut.AOut-
SignalAssign1
Word R/W
asgn AOut1(0=std,1=AdjStart,2=AdjEnd, 3=Rng-
C2)
3018 3018
Setup.In/Outputs.AnalogOut.AOut-
SignalAssign2
Word R/W
asgn AOut2 (0=std,1=AdjStart,2=AdjEnd, 3=Rng-
C2)
3019 3019
Setup.In/Outputs.AnalogOut.AOut-
SignalAssign3
Word R/W
asgn AOut3 (0=std,1=AdjStart,2=AdjEnd, 3=Rng-
C2)
3020 3020
Setup.In/Outputs.AnalogOut.AOut-
SignalAssign4
Word R/W
asgn AOut4 (0=std,1=AdjStart,2=AdjEnd, 3=Rng-
C2)
3021 3021 Setup.Calibration.ToleranceCheck Word R/W
check deviation tolerance (0=Off,1=On/
AutoClear,2=On)