Filter
Top Products
Emerson Process Management GmbH & Co. OHG4-30
X-STREAM X2
Instruction Manual
HASX2E-IM-HS
02/2012
4.6.3 Installation - X-STREAM X2XF Field Housings
If tted, the optional RJ45 connection is loca-
ted on an electronics board in the card cage
section of the unit (Fig. 4-9, pg. 4-23).
To install this connection, a cable must be
fed through the cable entry without a con-
nector.
The connector can be wired on when the free
end has been fed into the instrument:
We recommend the VARIOSUB RJ45 QUICK-
ON connector (PHOENIX CONTACT), which
is supplied with the unit and requires no spe-
cial tools. Wiring instructions can be found
in the separate manual supplied with the
connector.
Optional Modbus RJ45 connection
Fig. 4-23: X-STREAM X2XF Field Housings - Ethernet connector
Note!
Please note that although the Modbus termi-
nals
( previous page) are still installed,
they are not connected!
Pin 1 Pin 8
Pin no.
Signal
1 TX+
2 TX-
3 RX+
6 RX-
other
not
used