Filter
Top Products
Emerson Process Management GmbH & Co. OHG6-10
X-STREAM X2
Instruction Manual
HASX2E-IM-HS
02/2012
Cancel calibration!
ZeroAll!
SpanAll!
ZSCalAll!
Control..
Adv. calibration..
6.2.2.3 Advanced Calibration Menu
6.2 Menu System - Advanced Calibration Menu
Pressing the 8 key in this line will abort the
current calibration procedure and cancel any
changes.
Pressing the
8 key in this line will start the
zero calibration for all channels.
Pressing the 8 key in this line will start the
span calibration for all channels.
Pressing the
8 key in this line will start the
zero & span calibrations for all channels.
Note!
For further details on calibration procedures,
see
chapter 7 Maintenance.
Note!
This menu is also available in single-channel
units. In this case, the 2nd and 3rd lines will
start a zero or span calibration, while the 4th
line will allow the operator to start a zero and
a span calibration with a single keypress.
Note!
This menu is only available when the “Val-
ves” parameter in the INSTALLED OPTIONS
Menu is set to a parameter other than none.