Filter
Top Products
Emerson Process Management GmbH & Co. OHG 7-11
X-STREAM X2
Instruction Manual
HASX2E-IM-HS
02/2012
7
Maintenance & Procedures
Before starting to assign valves to gases and
channels, you need to check what type of
valves is used (external or internal):
Setup..
Installed Options..
Open the SETUP - INSTALLED OPTIONS..
menu and check the rst line ("Valves:")
Valves: Internal
COM-Interf: Yes
Pump: Yes
Flow monitor: Yes
If this menu (as the example to the left) shows
there are internal valves installed, open the
INTSHS menu ( 7.3.1.1.1, page 7-10) to
assign valves.
Valves: External
COM-Interf: Yes
Pump: Yes
Flow monitor: Yes
If the menu (as the example to the left) shows
there are external valves installed, open the
DIGITAL OUTPUTS menu ( 7.3.1.1.2
page 7-12) to assign valves.
Valves: Int+Ext
COM-Interf: Yes
Pump: Yes
Flow monitor: Yes
If the menu (as the example to the left) shows
there are internal and external valves in-
stalled, valve assignment has to be done
utilizing both, the INTSHS ( 7.3.1.1.1
page 7-10) and the DIGITAL OUTPUTS menu
( 7.3.1.1.2 page 7-12).
7.4.1 Preparing Calibrations