Filter
Top Products
Emerson Process Management GmbH & Co. OHG 6-59
X-STREAM X2
Instruction Manual
HASX2E-IM-HS
02/2012
6
Software Menus
6.2 Menu System - Status Menu
Multi-channel unit:
Select the component in the SELECT COM-
PONENT menu.
Multi-channel unit:
Press the key to enter the SELECT COM-
PONENT menu to select a different chan-
nel.
Displays the raw reference value of the de-
tector (for selected measurement principles
only).
RawRef 2.000000
RawMeas 1.000000
Ref/Meas 2.000000
CO2.1 134.1 ppm
Page 3
Displays the raw measuring value of the de-
tector. This is the signal without linearisation,
compensation or conversion.
Ratio of RawRef to RawMeas. This value can
be used for diagnostic purposes.
Current measurement value in the user-
dened measurement unit.
Note!
A value of 0 in one or both of the rst two
lines of page 4 is not necessarily an error.
Depending on the measuring procedure used,
a value of 0 may be valid.
At maximum 8 secondary values (pressure,
temperature, ow, source current) can be
shown. Source current values are shown only
if this limit is not yet reached.
If a temperature sensor is assigned to the
selected channel, this line shows the current
temperature.
If a ow sensor is assigned to the selected
channel, this line shows the current gas
ow.
TempSensor 50 °C
FlowSensor 1 l/min
SrcCurrent 1000 mA
Page 4
If the selected channel is an IR channel, this
line shows the IR source current.