Print Data *Manual Number Revision
Apr. 2005 SH(NA)030038-C Section 10.1 (5) (6): Added.
Section 11.1: d. HF-SP502
702 is added.
Section 11.2 (1): Table is examined.
Section 11.3: Dynamic brake time constant is added.
Chapter 12: "WARNING" 10 minutes are modified to 15 minutes.
Section 12.1.1: Combinations of cable and connector sets diagram is examined.
2) Servo amplifier power supply connector is added.
3) Power supply connector set is added.
Section 12.1.2 (1) (a): Encoder connector Crimping tool are added.
Section 12.1.2 (2) (a): Note is added.
Section 12.2 (1): MR-RB31 and MR-RB51 are added.
Section 12.2 (3): Parameter No.PA02 setting 01
08 09 are added.
Section 12.2 (4): "POINT" is added.
Content is examined.
Section 12.2 (5): MR-RB31 and MR-RB51 are added.
Section 12.5 (5) (b): Outline drawing is partially modified.
Section 12.3: Added.
Section 12.4: Added.
Section 12.6 (2) (a): The free space of the hard disk is changed to 130MB.
Section 12.7 (2): Added.
Section 12.8: Part of wiring diagram is added.
Table of crimping terminals and applicable tools is added.
Section 12.16: HF3040A-UN is added.
Section 13.4.1 (5): Current alarm data [0][1]
[0][8] [0][9] are deleted.
Section 13.4.2 (3): Error in reference page No. is corrected.
Section 13.4.2 (8): Data No.[2] [0] Content is changed.
Data No.[2] [1] The expression of test operation setting is
changed.
Chapter 14: Caution Sentence is added.
Description of AD75
is deleted.
Section 14.2 (2): QD75
is added.
Section 14.3 (2): Added.
Section 14.7.3 (2): Part of sentence is examined.
Section 17.8.2 (2) (c): Note 2 is added.
Section 17.8.2 (2) (f): Note 3 is added.
App. 6: Table is examined.
Oct. 2006 SH(NA)030038-D Servo amplifiers MR-J3-11KA to 22KA 11KA4 to 22KA4 are added.
Servo motors HC-RU
HC-UP HC-LP HA-LP HA-LP4 are added.
Safety Instructions: 4. (1) Environmental conditions table: Vibration is examined.
Safety Instructions: 4. (2) Caution is added.
Safety Instructions: 4. (4) Caution is added.
Section 1.2: Connection diagram is modified.
Addition of Note.
Section 1.3: 400VAC class supporting table is added.
Section 1.5 (2): Drawings are modified.
Section 1.7: Mounting hole is changed into fixing part.
Section 1.7.1 (5): Added.
Section 1.8 (5): Added.
Chapter 2: Caution is added.
Section 2.1 (2): Added.
Section 3.1 (1) to (4): Modified.
Section 3.1 (5): Added.
