Filter
Top Products
2 - 1
2. INSTALLATION
2. INSTALLATION
WARNING
To prevent electric shock, ground each equipment securely.
CAUTION
Stacking in excess of the limited number of product packages is not allowed.
Install the equipment to incombustibles. Installing them directly or close to
combustibles will led to a fire.
Install the equipment in a load-bearing place in accordance with this Instruction
Manual.
Do not get on or put heavy load on the equipment to prevent injury.
Use the equipment within the specified environmental condition range. (For details
of the environmental condition, refer to section 1.3.)
Provide an adequate protection to prevent screws, metallic detritus and other
conductive matter or oil and other combustible matter from entering the converter
unit and servo amplifier (drive unit).
Do not block the intake and exhaust areas of the converter unit, servo amplifier
(drive unit) and servo motor which has a cooling fan. Doing so may cause faults.
Do not subject the converter unit and servo amplifier (drive unit) to drop impact or
shock loads as they are precision equipment.
Do not install or operate a faulty converter unit and servo amplifier (drive unit).
When the product has been stored for an extended period of time, contact your local
sales office.
When handling the converter unit and servo amplifier (drive unit), be careful about
the edged parts such as the corners of the each unit.
The converter unit and servo amplifier (drive unit) must be installed in the metal
cabinet (control box).