Mitsumi electronic MR-J3- A Air Conditioner User Manual


 
5 - 38
5. PARAMETERS
No. Symbol Name and function
Initial
value
Unit
Setting
range
Control mode
Position Speed Torque
PC26 *COP5 Function selection C-5
Select the stroke limit warning (AL. 99).
Stroke limit warning (AL. 99) selection
0: Valid
1: Invalid
When this parameter is set to "1", AL. 99 will
not occur if the forward rotation stroke end
(LSP) or reverse rotation stroke end (LSN)
turns OFF.
000
0000h Refer to
name
and
function
column.
PC27 *COP6 Function selection C-6
Set this function if undervoltage alarm occurs because of
distorted power supply voltage waveform when using power
regenerative converter or power regenerative common
converter.
Setting when undervoltage alarm occurs
0: Initial value (Waveform of power supply voltage is not distorted)
1: Set "1" if undervoltage alarm occurs because of distorted power
supply voltage waveform when using power regenerative
converter or power regenerative common converter.
000
0000h Refer to
name
and
function
column.
PC28 For manufacturer setting 0000h
PC29 Do not change this value by any means. 0000h
PC30 STA2 Acceleration time constant 2
This parameter is made valid when the
acceleration/deceleration selection (STAB2) is turned ON.
Used to set the acceleration time required to reach the rated
speed from Or/min in response to the analog speed
command and internal speed commands 1 to 7.
0 ms 0
to
50000
PC31 STB2 Deceleration time constant 2
This parameter is made valid when the
acceleration/deceleration selection (STAB2) is turned ON.
Used to set the deceleration time required to reach Or/min
from the rated speed in response to the analog speed
command and internal speed commands 1 to 7.
0 ms 0
to
50000
PC32 CMX2 Command pulse multiplying factor numerator 2
Available when the parameter No.PA05 is set to "0".
1 1
to
65535
PC33 CMX3 Command pulse multiplying factor numerator 3
Available when the parameter No.PA05 is set to "0".
1 1
to
65535
PC34 CMX4 Command pulse multiplying factor numerator 4
Available when the parameter No.PA05 is set to "0".
1 1
to
65535