Filter
Top Products
Automatic Slot Configuration
DSX Software Manual Features ◆ 33
Features
Automatic Slot Configuration
Description
Automatic Slot Configuration automatically sets up station and line PCBs when you initially power up the
system. This simplifies installation because you don’t have to use system programming to activate station
and line PCBs after you plug them in.
Here’s how Automatic Slot Configuration works:
1. With power off, install your station and line PCBs.
2. With the system powered down, install the station and line PCBs from left to right in the order you want
your extension and line numbers set up.
• Be sure to install a 16ESIU PCB in the first slot (CN1).
• You don’t have to group your station and line PCBs together, although it may be more convenient to
do so.
3. Power up the system.
4. On power up, the system scans the PCBs from left to right and sets up the extension and line numbering
as follows.
• Extension numbers will begin with 300 in the first slot and increment from left to right.
• Line numbers will begin with 101 (starting from the first installed line PCB) and will also increment
from left to right.
System reset does not cause reconfiguration. Automatic Slot Configuration is temporarily disabled during a
system reset.
Programming
1. Use 120x-Stations (page 611) to reconfigure your station PCBs.
1. Use 121x-Lines (page 614) to reconfigure your line PCBs.
Other Related Features
None
Operation
N/A
The system automatically installs PCBs when you power up the system.
1. Optionally reconfigure station PCBs after the initial installation.
2. Optionally reconfigure line PCBs after the initial installation.