Filter
Top Products
Start-Up Programming
396 ◆ IntraMail Features DSX Software Manual
Start-Up Programming
Start-Up IntraMail Programming
1. Add additional IntraMail mailboxes as required.
- In 2141-01: Station Mailbox Type (page 766), enter 1. This enables a Subscriber Mailbox for the
extension.
- By default in DSX-80/160, the first 16 mailboxes are enabled (extensions 300-315).
- By default in DSX-40, the first 8 mailboxes are enabled (extensions 300-307).
1. In 3112-01: Direct Termination in the Day (page 819), enter 700.
1. In 3112-04: Direct Termination at Night (page 820), enter 700.
1. In 3131-02: IntraMail Answer Table Assignment (page 828), check the line’s Answer Table assignment.
- Initially, you should leave all lines assigned to Answer Table 1.
- See Answer Tables (page 420) for more.
1. The block diagram below shows the default Automated Attendant configuration.
1. Enable the mailboxes for all installed extensions (not for Built-In Automated Attendant).
2. Set up the Automated Attendant to answer outside calls during the day.
3. Set up the Automated Attendant to answer outside calls at night.
4. Check the Answer Table assignment.
5. Review the default Automated Attendant setup.
DIL to Voice Mail
Master (700)
Lines Route to
Answer Table 1
Answer Table 1
Schedule 1 or
Default
Mailbox
Dial Action
Table 1
● 3131-02: Answer Table
● 421x-Answer Table
Calls always route to Call Routing Mailbox 001
- Schedule 1 active M-F 8:30AM-5:00PM.
- Default Mailbox active all other times.
● 423x: Dial Action Tables
Dial Action Table 1
Dialing Options
Dial an extension number, or
0 for the operator
Automated Attendant Answering (Default)
All Lines
Use Answer
Table 1
Which Chooses Call
Routing Mailbox 001.
And Dial Action
Table 1
With these
dialing options
Automated Attendant
V-MAIL + SA + I + 001
Built-In Automated Attendant
#AG + 001
● 422x: Routing Mailboxes (001)
● 3112-01: Direct Termination (Day)
● 3112-04: Direct Termination (Night)
Call Routing
Mailbox 001
● 4212: Schedule
●
4211-01: Default Mailbox
To record a new Instruction Menu
Message (from Extension 300):