Filter
Top Products
2-10
Cisco SFS 7000 Series Product Family Command Reference Guide
OL-9163-02
Chapter 2 Administrative Commands
boot-config
boot-config
To specify the system image to run when your Server Switch boots, enter the
boot-config
command in
Global Configuration mode.
boot-config primary-image-source
dir
Syntax Description
Defaults This command has no default settings.
Command Modes Global Configuration (config) mode.
Usage Guidelines
Platform Availability:
Cisco SFS 3001, Cisco SFS 7000, Cisco SFS 7008, Cisco SFS 3012, Cisco 4x InfiniBand Switch Module
for IBM BladeCenter
Privilege Level:
Unrestricted read-write user.
Specify an image directory as a boot image. Do not specify image files that end in “.img” since these are
compressed archives that must be installed first.
Note Use the
dir
command with the image keyword to view a list of images on your device.
Examples The following example configures the Server Switch controller to use the sfsOS-1.1.0/build460 directory
when the Server Switch boots. Without this directory, the system cannot boot successfully.
SFS-7000P(config)# boot-config primary-image-source sfsOS-1.1.0/build460
Related Commands dir
install
radius-server
reload
show boot-config
show card
show card-inventory
primary-image-source Specifies that you want to configure the boot image.
dir Directory that contains the boot image.