Filter
Top Products
6-45
Cisco SFS 7000 Series Product Family Command Reference Guide
OL-9163-02
Chapter 6 Show Commands
show diagnostic interface ib
Examples The following example displays the completed and ongoing diagnostic tests on port 1 of InfiniBand
switch card 16:
SFS-7000P> show diagnostic interface ib 16/1
================================================================================
Diagnostic Tests For IB Interfaces
================================================================================
test : external-loopback
port : 16/1
validation : enabled
data-size : 0
data-pattern : 00:00:00:00
iterations : 0
source-id : 00:00:00
target-id : 00:00:00
action : stop
result : none
percentage-completed : 0
result-string : External Loopback Test Unknown status, Current report :
Passed=0, Failed=0, Total=0
The following example displays the available diagnostics tests:
SFS-7000P(config)# diagnostic interface ib 16/1
> SFS-7000P(config-diag-if-ib-16/1)# ?
> diagnostic Configuration Commands:
> data-pattern - Configure a data pattern to use in traffic test
> cases
> exit - Exit current mode
> help - Show command help
> history - Show command history
> iterations - Configure number of iterations the test case
> should be run
> no - Disable a configuration or set default
> start - Initiate a test
> stop - Stop a test
> test - Configure the test case to run
> validate - Enable data validation to be performed on
> received packets
> SFS-7000P(config-diag-if-ib-16/1)# test ?
> ext-cable - Configure External-Cable test
> ext-loopback - Configure External-Loopback test
> int-loopback - Configure Internal-Loopback test
Related Commands show diagnostic