Filter
Top Products
7-226
Cisco SFS 7000 Series Product Family Command Reference Guide
OL-9163-02
Chapter 7 Diagnostic Commands
test
test
Specify a diagnostic test to run with the test command in appropriate Diagnostic Configuration submode.
test {echo | int-loopback | ext-loopback | led | self-test}
Note The SFS 7000 does not support external loopback tests for InfiniBand interfaces. Table 7-8 describes
the different tests that you can run and the interfaces or cards on which you can run them.
Syntax Description
Defaults This command has no default settings.
Command Modes Fibre Channel Interface Diagnostic Configuration (config-diag-if-fc) submode, Ethernet Interface
Diagnostic Configuration (config-diag-if-en) submode, InfiniBand Interface Diagnostic Configuration
Usage Guidelines
Platform Availability:
Cisco SFS 3001, Cisco SFS 7000, Cisco SFS 7008, Cisco SFS 3012, Cisco 4x InfiniBand Switch Module
for IBM BladeCenter
Privilege Level:
Read-write user.
Examples The following example specifies a LED test to run on card 11 when the start command executes:
SFS-7000P (config-diag-card-11)# test LED
Related Commands diagnostic
show interface ethernet
show interface fc
show interface gateway
start
stop
echo Echo test (Fibre Channel gateway only).
int-loopback Internal loopback test (unsupported).
ext-loopback External loopback test (Fibre Channel gateway only).
led LED test.
self-test Self test.
ext-cable External cable test (unsupported).