Filter
Top Products
6-10
Cisco SFS 7000 Series Product Family Command Reference Guide
OL-9163-02
Chapter 6 Show Commands
show boot-config
show boot-config
To display the active system image that runs when your Server Switch boots, enter the
show
boot-config
command in User Exec mode or Privileged Exec mode.
show boot-config
Syntax Description This command has no arguments or keywords.
Defaults No default behavior or values
Command Modes User Execute mode, Privileged Execute mode.
Usage Guidelines
Platform Availability:
Cisco SFS 3001, Cisco SFS 7000, Cisco SFS 7008, Cisco SFS 3012, Cisco 4x InfiniBand Switch Module
for IBM BladeCenter
Privilege Level:
General read-only user.
The
show boot-config
command displays the image that initializes chassis firmware and configures
the interfaces.
This command lists the files that were used to bring up the system, the files to use the next time the
system reboots, and the backup files to use in the event that the primary boot files are not available.
Command Output:
Table 6-4 describes the fields in the
show boot-config
command output.
Table 6-4 show boot-config Command Field Descriptions
Field Description
slot-id Slot identifier of the controller card in use.
sw-version Version of the software image that initialized chassis components.
last-image-source Directory name of the active system image used to initialize chassis
components.
primary-image-source Name and directory location of the active system image to use to initialize
chassis components the next time the system boots.