Filter
Top Products
5-12
Cisco SFS 7000 Series Product Family Command Reference Guide
OL-9163-02
Chapter 5 IP Commands
trunk-group
trunk-group
To assign a trunk group to one or more Ethernet interfaces, enter the
trunk-group
command in Ethernet
Interface Configuration submode. To remove a trunk group from the configuration, enter the
no
form of
this command.
trunk-group
id
no trunk-group
id
Syntax Description
Defaults By default, trunk groups do not apply to interfaces.
Command Modes Ethernet Interface Configuration (config-if-ether) submode.
Usage Guidelines
Platform Availability:
Cisco SFS 3001, Cisco SFS 3012
Privilege Level:
Ethernet read-write user.
The
trunk-group
command assigns an already-configured trunk group to the Ethernet interface.
Examples The following example assigns a trunk group to the Ethernet interface (slot 2, ports 1 - 4):
SFS-7000P(config-if-ether-2/1-2/4)# trunk-group 2
Related Commands config TACACS-server host
show trunk
show interface ethernet
id Integer that identifies the trunk-group.