Filter
Top Products
7-217
Cisco SFS 7000 Series Product Family Command Reference Guide
OL-9163-02
Chapter 7 Diagnostic Commands
diagnostic
diagnostic
To enter Diagnostic Configuration submode, enter the diagnostic command in Global Configuration
mode.
diagnostic {card {card-selection | all} | chassis | interface
{fc | ib | ethernet} {interface-selection
| all} | fan {fan-number | all} | power-supply {supply | all} | rack-locator {locator | all}}
Note Not all syntax applies to all hardware platforms. Enter Diagnostic submode to run test on cards and
interfaces.
Syntax Description
Defaults This command has no default settings.
Command Modes Global Configuration (config) mode.
Usage Guidelines
Platform Availability:
Cisco SFS 3001, Cisco SFS 7000, Cisco SFS 7008, Cisco SFS 3012, Cisco 4x InfiniBand Switch Module
for IBM BladeCenter
Note The SFS 3001 and SFS 3012 can run card and interface tests only. For the SFS 7000 and SFS 7008, the
rack-locator keyword supports only 12x, not 4x.
Privilege Level:
Read-write user for the appropriate technology.
card Enters Card Diagnostic Configuration submode.
card-selection Card, list of cards, or range of cards to diagnose.
chassis Configures chassis-specific diagnostic tests.
fan Configures fan-specific diagnostic tests.
interface Enters Interface Diagnostic Configuration submode.
fc Specifies Fibre Channel interfaces.
ib Specifies InfiniBand interfaces.
ethernet Specifies Ethernet interfaces.
interface-selection Interface, list of interfaces, or range of interfaces to diagnose.
all Specifies all interfaces of the technology type that you specified for all
cards.
power-supply Configures power supply-specific diagnostic tests.
rack-locator Configures rack locator-specific diagnostic tests.