Filter
Top Products
6-199
Cisco SFS 7000 Series Product Family Command Reference Guide
OL-9163-02
Chapter 6 Show Commands
show sensor
show sensor
To display the temperature at several key locations in your Server Switch, enter the
show sensor
command in User Exec mode or Privileged Exec mode.
show sensor
Syntax Description This command has no arguments or keywords.
Defaults This command has no default settings.
Command Modes User Execute mode, Privileged Execute mode.
Usage Guidelines
Platform Availability:
Cisco SFS 3001, Cisco SFS 7000, Cisco SFS 7008, Cisco SFS 3012, Cisco 4x InfiniBand Switch Module
for IBM BladeCenter
Privilege Level:
General read-only user.
The
show sensor
command identifies the temperature sensors in the system chassis. It also reports their
location in the chassis and the current temperature at that location. Chassis temperature should be
monitored to verify the cooling efficiency of the blowers and your data center air-conditioning.
Temperatures are in degrees Celsius and vary depending upon their location.
Normal temperature levels for the Cisco SFS 3001 remain 10 to 20 degrees Celsius above the ambient
temperature.
75 C would be an alarm temperature and the system will reset itself at 85 C.
Command Output:
Table 6-60 describes the output of the show sensor command.
Table 6-80 show sensor Command Field Descriptions
Field Descriptions
sensor Number of the temperature sensor.
oper-status Operational status of the sensor (“up” or “down”).
oper-code (select Server Switches) Operational code of the sensor.
temperature Temperature that the sensor reads, in degrees Celsius.
alarm-temp (select Server Switches) Temperature at which the sensor sounds an alarm.
shutdown-temp (select Server Switches) Temperature at which the sensor shuts down the Server
Switch.