Filter
Top Products
5-3
Cisco SFS 7000 Series Product Family Command Reference Guide
OL-9163-02
Chapter 5 IP Commands
bridge-group
bridge-group
To create and configure bridge groups, enter the
bridge-group
command in Global Configuration mode
or Ethernet Interface Configuration submode. To remove bridge groups or attributes of bridge groups,
use the
no
form of this command.
bridge-group
bridgegroupID {
broadcast-forwarding
|
eth-next-hop
ip-address [
dest
dest-addr dest-mask] |
ib-next-hop
ip-address [
dest
dest-addr dest-mask] |
name
“
name-string
”
|
subnet-prefix
prefix length |
loop-protection
{
one
|
two
} |
multicast
|
fail-over-priority
priority |
redundancy-group
group}
bridge-group
bridgegroupID [
pkey
partition-key]
no bridge-group
bridgegroupID [
broadcast-forwarding
|
eth-next-hop
|
ib-next-hop
|
loop-protection
{
one
|
two
} |
multicast
|
redundancy-group
group]
no bridge-group
bridgegroupID [
pkey
|
subnet-prefix
prefix length]
Syntax Description
Defaults This command has no default settings.
bridgegroupID Bridge group to create or reconfigure.
broadcast-forwarding (Optional) Enables broadcast forwarding for the bridge group.
eth-next-hop (Optional) Identifies the next-hop IP address connected to the ethernet
gateway.
ip-address (Optional) Next-hop IP address
ib-next-hop (Optional) Identifies the next-hop IP address connected to the IB switch.
loop-protection (Optional) Specifies the type of loop protection for the bridge-group.
one Specifies type one loop protection (ARP packet painting enabled).
two Specifies type two loop protection (ARP packet painting disabled).
multicast (Optional) Enables IP-V4 multicast forwarding for the bridge group.
name Assigns an ASCII text string identifier to the bridge group.
name-string ASCII text string identifier for the bridge group.
subnet-prefix (Optional) Assigns a subnet to the bridge-group.
prefix (Optional) Subnet to assign to the bridge group.
length (Optional) Length, in bits, of the subnet mask to assign to the bridge group.
fail-over-priority Specifies the failover priority of the bridge group.
priority Integer value (1 - 255), where the lower the integer the higher the priority.
redundancy-group (Optional) Assigns the bridge group to a redundancy group.
group (Optional) Redundancy group to which you want the bridge group to belong.
pkey (Optional) Specifies a partition key to assign to the bridge group.
partition-key Partition key to assign to the bridge group.
dest (Optional) Specifies the destination subnet.
dest-addr (Optional) Address of the destination subnet.
dest-mask (Optional) Mask of the destination subnet.