Filter
Top Products
4-5
Cisco SFS 7000 Series Product Family Command Reference Guide
OL-9163-02
Chapter 4 InfiniBand Commands
ib pm
Defaults Performance monitoring is disabled by default.
Command Modes Global Configuration (config) mode.
Usage Guidelines
Platform Availability
Cisco SFS 3001, Cisco SFS 7000, Cisco SFS 7008, Cisco SFS 3012, Cicso 4x InfiniBand Switch Module
for IBM BladeCenter
Privilege Level:
InfiniBand read-write access
Use performance manager to do the following:
• View IB port counters.
• Test connectivity between two IB ports (test a connection).
• Monitor any/all IB ports for errors, generating SNMP traps and log messages when user-defined
thresholds are exceeded.
To monitor IB ports for errors, follow these steps:
• Configure error thresholds.
• (Optional) Configure specific ports and/or connections to monitor.
• (Optional) Configure new start-delay and/or polling-period values.
• Start performance monitoring.
threshold Configures threshold values.
excess-buf-overruns Configures the threshold for the number of “excess buffer overrun” errors.
link-downs Configures the threshold for the number of “link down” errors.
link-recovery-errors Configures the threshold for the number of “link recovery” errors.
local-link-errors Configures the threshold for the number of “local link integrity” errors.
rcv-constrnt-errors Configures the threshold for the number of “receive constraint” errors.
rcv-errors Configures the threshold for the number of “receive” errors.
rcv-rate Configures receive rate thresholds.
rcv-rem-phy-errors Configures the threshold for the number of “receive remote physical”
errors.
rcv-sw-relay-errors Configures the threshold for the number of “receive remote relay” errors.
symbol-errors Configures the threshold for the number of “symbol” errors.
vl15-droppeds Configures the threshold for the number of “vl15 dropped” events.
xmit-constrnt-errors Configures the threshold for the number of “transmit constraint” errors.
xmit-discards Configures the threshold for the number of “transmit discard” errors.
xmit-rate Configures transmit rate thresholds.
int Threshold value (integer).