Filter
Top Products
7-223
Cisco SFS 7000 Series Product Family Command Reference Guide
OL-9163-02
Chapter 7 Diagnostic Commands
start
start
To begin a diagnostic test, enter the start command in the appropriate Interface DiagnosticConfiguration
submode.
start
Syntax Description This command has no arguments or keywords.
Defaults This command has no default settings.
Command Modes Fibre Channel Interface Diagnostic Configuration (config-diag-if-fc) submode, Ethernet Interface
Diagnostic Configuration (config-diag-if-en) submode, or Card Interface Diagnostic Configuration
(config-diag-if-card) submode.
Usage Guidelines
Platform Availability:
Cisco SFS 3001, Cisco SFS 7000, Cisco SFS 7008, Cisco SFS 3012, Cisco 4x InfiniBand Switch Module
for IBM BladeCenter
Privilege Level:
Unrestricted and general read-write user.
Examples The following example starts a LED diag test on a Fibre Channel interface:
SFS-7000P(config-diag-if-fc-4/1)# test led
SFS-7000P(config-diag-if-fc-4/1)# start
The following example starts a self-test diagnostic test on a card:
FS-7000P (config-diag-card-6)# test self-test
SFS-7000P (config-diag-card-6)# start
Related Commands diagnostic
show interface ethernet
show interface fc
show interface gateway
stop
test