Filter
Top Products
6-174
Cisco SFS 7000 Series Product Family Command Reference Guide
OL-9163-02
Chapter 6 Show Commands
show interface ib
Command Output:
Table 6-73 describes the fields that appear when you use the
statistics
keyword with the
show
interface ib
command.
resp-timeout Maximum time allowed between the port reception of a subnet
management packet and the transmission of the associated response. For
more information, see InfiniBand Architecture®, Vol. 1, Release 1.1,
section 13.4.6.2, “Timers and Timeouts.”
local-phys-err Threshold at which ICRC, VCRC, FCCRC, and all physical errors result
in an entry into the BAD PACKET or BAD PACKET DISCARD states of
the local packet receiver. For more information, see InfiniBand
Architecture®, Vol. 1, Release 1.1, section 7.12.2, “Error Recovery
Procedures.”
overrun-err Threshold at which buffer count overruns across consecutive flow-control
update periods and results in an overrun error.
Table 6-72 sma port-info details Keyword Output Field Descriptions (continued)
Field Description
Table 6-73 statistics Keyword Output Field Descriptions
Field Description
port Port identifier, in slot#/port# format.
name Administrative port name that you configured with the
name
command.
in-octets Cumulative number of octets that arrived at the port, including framing
characters.
in-ucast-pkts Cumulative number of incoming packets destined for a single port.
in-multicast-pkts Cumulative number of incoming packets destined for the ports of a multicast
group.
in-broadcast-pkts Cumulative number of incoming packets destined for all ports on the fabric.
in-discards Cumulative number of inbound packets that the port discarded for a reason other
than a packet error (for example, lack of buffer space).
in-errors Number of inbound packets with errors that the port discarded.
in-unknown-protos For packet-oriented interfaces, the number of packets that were received through
the interface that were discarded because of an unknown or unsupported
protocol. For character-oriented or fixed-length interfaces that support protocol
multiplexing, the number of transmission units received through the interface
that were discarded because of an unknown or unsupported protocol. For any
interface that does not support protocol multiplexing, this counter is always 0.
out-octets Total number of octets transmitted out of the interface, including framing
characters.
out-ucast-pkts Total number of packets that higher-level protocols requested be transmitted and
that were not addressed to a multicast or broadcast address at this sub-layer,
including those that were discarded or not sent.