Filter
Top Products
6-168
Cisco SFS 7000 Series Product Family Command Reference Guide
OL-9163-02
Chapter 6 Show Commands
show interface ib
type Identifies the type of the InfiniBand card.
Supported cards are ib1xTX, ib1xFX, ib4xTX,
ib4xFX, and ib4xTXP. This field is set by the
type
command.
desc Description of the port, in slot#/port# format. The
number in parentheses serves as the SNMP
identifier.
last-change Time at which the InfiniBand port configuration
was last changed.
mtu Maximum Transmission Unit for the InfiniBand
port. Used to configure the MTU size of IP
network traffic.
auto-negotiate supported (select Server Switches) Displays "yes" if the port supports
auto-negotiation or "no" if the port does not
support auto-negotiation.
auto-negotiate (select Server Switches) Indicates if the InfiniBand port on the interface
card is configured to automatically negotiate
connection parameters when it connects with an
InfiniBand device. If auto-negotiation is enabled,
the connection speed is determined at the time of
connection. If the device does not support
auto-negotiation, this field still displays a value,
but the value does not apply. The value is enabled
or disabled. The default is disabled. This field is
set by the
auto-negotiate
command.
admin-status Indicates if you have enabled the port for
configuration and use. The value of this field may
be up or "down." The default is "down." The field
is set by the
shutdown
command.
oper-status Indicates if the port is physically ready for
configuration and use. The value of this field may
be up or "down." If this field is down but the
admin-status is up, check that the InfiniBand
interface card is securely seated in the slot and a
cable is attached between the port and the target
InfiniBand host.
admin-speed (select Server Switches) Indicates the speed administratively assigned to
the InfiniBand port. You can configure this setting
with the
speed
command.
oper-speed (select Server Switches) Indicates the maximum speed of the InfiniBand
port, based upon the attached InfiniBand cable and
polling the connected InfiniBand device.
Table 6-69 show interface ib Command Field Descriptions (continued)
Field Description