Filter
Top Products
7-219
Cisco SFS 7000 Series Product Family Command Reference Guide
OL-9163-02
Chapter 7 Diagnostic Commands
data-pattern
data-pattern
To specify a data pattern when you run a diagnostic test on an interfaces, enter the data-pattern command
in Interface Diagnostic Configuration submode. To clear the data pattern, use the no form of this
command.
data-pattern pattern
no data-pattern pattern
Syntax Description
Defaults This command has no default settings.
Command Modes Interface Diagnostic Configuration (config-diag-if) mode.
Usage Guidelines
Platform Availability:
Cisco SFS 3001, Cisco SFS 7000, Cisco SFS 7008, Cisco SFS 3012, Cisco 4x InfiniBand Switch Module
for IBM BladeCenter
Privilege Level:
Unrestricted and general read-write user.
Examples The following example configures the data pattern that runs during a diagnostic test:
SFS-7000P(config-diag-if-fc-4/1)# data pattern 11:22:33:44
Related Commands test
diagnostic
start
stop
show interface ethernet
show interface fc
show interface ib
pattern Artificial traffic pattern to create for testing purposes.