Filter
Top Products
7-225
Cisco SFS 7000 Series Product Family Command Reference Guide
OL-9163-02
Chapter 7 Diagnostic Commands
target-wwpn
target-wwpn
To configure an optional WWPN identifier for a Fibre Channel interface Echo test, enter the
target-wwpn command in Fibre Channel Interface Diagnostic Configuration submode.
source-wwpn wwpn
no source-wwpn wwpn
Syntax Descriptionn
Defaults This command has no default settings.
Command Modes Configuration Diag Interface Fibre Channel (config-diag-if-fc) submode.
Usage Guidelines
Platform Availability:
Cisco SFS 3001, Cisco SFS 7000, Cisco SFS 7008, Cisco SFS 3012, Cisco 4x InfiniBand Switch Module
for IBM BladeCenter
Privilege Level:
Fibre Channelread-write user.
Examples The following example enables database synchronization on the IB fabric:
SFS-7000P(config-diag-if-fc-4/1)# ib sm db-sync subnet-prefix fe:80:00:00:00:00:00:00
enable
Related Commands diagnostic
show interface ethernet
show interface fc
show interface gateway
start
stop
test
wwpn Optional 24-bit source identifier to use with the Fibre Channel interface
Echo test.