Filter
Top Products
4
- 4
4.2 Settings and Procedure to Operation
4
SETTINGS AND PROCEDURE TO OPERATION
Figure 4.2 MES interface module start-up procedure
Configuration computer
According to [Network settings], connect the MES interface module and configuration computer to a network.
Configure the settings in MES Interface Function
Configuration Tool for the MES interface function.
Set the target MES interface module.
Write the project to the MES interface module.
(From the previous page) (From the previous page)
Power ON the programmable controller.
Check communications with the MES interface module by
executing the PING command in the command prompt
screen.
*5
Operation
When changing
the settings
MES interface module
Power OFF the programmable controller.
Set the target MES interface module.
Write a project to the MES interface module.
Section 2.1.4 System configuration for operation
• Chapter 6 FUNCTIONS
• Section 7.6 System Setting
• Section 7.7 Access Target CPU Setting
• Section 7.8 Device Tag Setting
• Section 7.9 Server Service Setting
• Section 7.10 Job Setting
• Section 7.11 Job Setting - Actions
• Section 7.12.1 Setting the target MES interface
module
• Section 7.12.2 Writing the MES interface
function settings
• Section 7.12.1 Setting the target MES interface
module
• Section 7.12.2 Writing the MES interface
function settings