Filter
Top Products
4
- 10
4.5 Intelligent Function Module Switch Settings
4
SETTINGS AND PROCEDURE TO OPERATION
(1) Mode setting (Switch 1)
Select the MES interface module operation mode.
(2) Default operation setting/battery error detection setting (Switch 2)
Select the default operation setting/battery error detection setting for the MES
interface module.
(a) Default operation setting (bit 0, 1)
Set whether to operate [Account setting] and [Network settings] with their default.
1) [Account setting] (bit 0)
0: Operates according to [Account setting].
1: Operates according to the default.
2) [Network settings] (bit 1)
0: Operates according to [Network settings].
1: Operates according to the default.
Table 4.5 Setting items of the [Switch setting for I/O and intelligent function module] dialog box
Switch number Description
Switch 1 Mode setting
Switch 2 Default operation setting/battery error detection setting
Switch 3 (Lower byte) Response monitoring time setting
Switch 4 to 5 For system use (Do not set.)
Table 4.6 Mode setting (Switch 1) setting items
Setting
number
Item Description
0000h Online Normal operation mode
0001h Hardware test
Tests the ROM/RAM/intelligent function module switch settings.
( Section 4.6.2 Hardware test)
0002h Self-loopback test
Executes the 10BASE-T/100BASE-TX interface self-diagnostics
test. ( Section 4.6.1 Self-loopback test)
Figure 4.9 Default operation setting/battery error detection setting (Switch 2)
b15 to b0b1b2
Default operation setting [Account setting]
Default operation setting [Network settings]
Battery error detection setting
1: Does not detect battery errors.
0: Detects battery errors.
Specify "0". * Switch 2
* When other than 0 is specified in this area,
"Switch setting error" (0180h) occurs at hardware test.
b3
0: Operates according to [Account setting].
1: Operates according to the default.
User name :QJ71MES96
Password :MITSUBISHI
0: Operates according to [Network settings].
1: Operates according to the default.
IP ADDRESS:192.168.3.3
Subnet mask:255.255.255.0