Filter
Top Products
10
TROUBLESHOOTING
10.2 Error Code List
10.2.1 Error codes for the MES interface module
10
- 7
9
XML MESSAGE
FORMAT
10
TROUBLESHOOTINGAPPENDICESINDEX
10.2 Error Code List
The error code list is shown below.
10.2.1 Error codes for the MES interface module
(To the next page)
Table 10.3 Error codes for the MES interface module
Error code Error name Description Action
0001h System error —
• Please consult your local Mitsubishi
representative.
0002h Response time-out error
No response has been received
from the other station.
• Correct [Access target CPU settings].
• Check the communication cable status
and access target CPU status.
• Correct the response monitoring time
setting.
Section 4.5 (3) Response
monitoring time setting (Switch 3
(Lower byte))
• Check the routing parameter set for the
CPU(s) on the access route.
• Check the control CPU(s) of the
network module(s) on the access route
to the access target CPU module.
Section 3.2 (2) Accessible routes
• Check if the access target PLC series
is supported.
Section 3.2 (1) Accessible CPU
modules
0041h
to
0044h
System error —
• Please consult your local Mitsubishi
representative.
0045h Processing code error
A processing code that is not
supported was issued.
• Check the CPU(s) on the access route.
0046h
Station No. specification
error
The specified station number is
incorrect.
• Check the station number setting in
[Access target CPU settings].
0047h Receive data error Data have not been received. • Check the CPU(s) on the access route.
0048h
System error —
• Please consult your local Mitsubishi
representative.
0049h
004Dh
004Eh
0050h
0051h
0055h Channel No. error
The RUN write setting of the
Ethernet module is disabled.
• Check the Ethernet module setting of
the access target CPU.
0064h System error —
• Please consult your local Mitsubishi
representative.
0065h Routing parameter error No routing parameter has been set.
• Check the routing parameter set for the
CPU(s) on the access route.
0066h Data send error Failed to send the data.
• Check the CPU(s) on the access route.
0067h Data receive error Failed to receive the data.
0080h Read size error The read size is not correct.