Filter
Top Products
4
SETTINGS AND PROCEDURE TO OPERATION
4.7 CompactFlash Card
4.7.2 Installation/removing the CompactFlash card
4
- 19
1
OVERVIEW
2
SYSTEM
CONFIGURATION
3
SPECIFICATIONS
4
SETTINGS AND
PROCEDURE TO
OPERATION
5
INSTALLATION AND
UNINSTALLATION
6
FUNCTIONS
7
MES INTERFACE
FUNCTION
CONFIGURATION TOOL
8
DB CONNECTION
SERVICE AND
SETTING TOOL
(3) Removing a CompactFlash card
1 Open the LED cover on the front of the MES interface module, then remove the
CompactFlash card.
• Put the finger at the bottom of the LED cover that is on the front of the MES
interface module, and lift the LED cover to open.
• When ejecting the CompactFlash card from the MES interface module, press
the EJECT button to push the CompactFlash card out.
Remark
When having difficulty in replacing the CompactFlash card, the following tweezers
are available.
Product: Plastic tweezers
Model name: NK-2539
2 Attach the CompactFlash card slot cover and close the LED cover on the front of
the MES interface module.
• Attach the CompactFlash card slot cover.
When the CompactFlash card is not installed, attach the CompactFlash card
slot cover.
• Lower the LED cover on the front of the MES interface module until it clicks.
Figure 4.16 CompactFlash card removal
Figure 4.17 Replacing the CompactFlash card using Plastic tweezers
EJECT button
CompactFlash card slot
LED cover
CompactFlash card
Remove in this
direction.
Press
EJECT button
QJ71MES96
SD/
RD
100
M
10BASE-T/
100BASE-TX
CF CARD
PULL