Filter
Top Products
4
- 16
4.7 CompactFlash Card
4.7.2 Installation/removing the CompactFlash card
4
SETTINGS AND PROCEDURE TO OPERATION
(Removal or replacement of the CompactFlash card)
Before removing or replacing the CompactFlash card, be sure to stop file access by the
following procedure.
Not following the procedure may cause the data corruption in the CompactFlash
card being accessed or a file system error.
Figure 4.12 Removal or replacement of the CompactFlash card
Removal/replacement of a CompactFlash card
Is the programmable
controller power ON?
YES
NO
Operation restarted?
YES
NO
End
Power ON the programmable controller.
Install a new
CompactFlash card?
YES
NO
Power OFF the programmable controller.
Disable the read from/write to the CompactFlash card by
file access stop processing.
Remove the CompactFlash card.
Install a new CompactFlash card.
Turn the power OFF and ON, or reset the programmable
controller CPU to restart the MES interface module.
Check that file access is active by the following:
CompactFlash card status (X1): ON
File access status (X2): OFF
(1) Stopping file access
(3) Removing a CompactFlash card
(2) Installation of the CompactFlash card