Filter
Top Products
Customizing & Branding Your ReadiVoice System
Proprietary & Confidential 159
With the standard toggle option, pressing
*4
locks a conference and pressing
*4
again unlocks it. To enable this configuration, change the relevant lines to
look like this:
*4 = eCMD_LOCK_TOGGLE
//*4 = eCMD_CONF_LOCK
//*5 = eCMD_CONF_UNLOCK
You can, of course, change the DTMF key sequence(s) used in either
configuration, but you’ll also have to change the relevant voice prompts (see ).
Mute/Unmute
Muting and unmuting of individual lines can be controlled either with two
separate commands or with a single command that toggles the mute state of
the channel.
The default
ive.ini
file (Figure 7-1 on page 157) enables the two-command
option;
*6
mutes the line of the person entering the command and
*7
unmutes
it. The relevant lines in
ive.ini
look like this:
//*6 = eCMD_MUTE_TOGGLE
*6 = eCMD_MUTE
*7 = eCMD_UNMUTE
With the standard toggle option, pressing
*6
mutes the line of the person
entering the command and pressing
*6
again unmutes it. To enable this
configuration, change the relevant lines in
ive.ini
to look like this:
*6 = eCMD_MUTE_TOGGLE
//*6 = eCMD_MUTE
//*7 = eCMD_UNMUTE
You can, of course, change the DTMF key sequence(s) used in either
configuration, but you’ll also have to change the relevant voice prompts (see ).
You can also customize the system’s mute confirmation behavior. See
“Customizing Confirmation Sounds” on page 162.
Caution!
If you enable the eCMD_LOCK_TOGGLE command, you must disable both the
eCMD_CONF_LOCK and eCMD_CONF_UNLOCK commands.
Caution!
If you enable the eCMD_MUTE_TOGGLE command, you must disable both the
eCMD_MUTE and eCMD_UNMUTE commands.