Filter
Top Products
ReadiVoice Administration & Maintenance Guide
158 Proprietary & Confidential
5 To enable a disabled command, remove the two slashes (
//
) at the
beginning of the line.
6 To change the DTMF key sequence that invokes a command, edit the two
characters to the left of the equal sign for that command.
7 When you’re finished making changes, save and close the
ive.ini
file.
8 Reboot the bridges so that they read the updated
ive.ini
file and load
the new
.wav
files.
9 Set up a test conference and verify that the touchtone commands you
modified work as intended and that the voice prompts are correct.
10 Make sure your teleconferencing users are aware of the changes.
Detailed Information for Specific Touchtone Features
This section provides more detailed information about the following
touchtone command features and how they can be implemented:
• Lock/Unlock
• Mute/Unmute
• Mute All / Unmute All
• Listen Only / Unlisten Only
• Private and Conference Roll Call
Lock/Unlock
Conference locking and unlocking can be controlled either with two separate
commands or with a single command that toggles the lock state of the
conference.
The default
ive.ini
file (Figure 7-1 on page 157) enables the two-command
option;
*4
locks a conference and
*5
unlocks it. The relevant lines look like
this:
//*4 = eCMD_LOCK_TOGGLE
*4 = eCMD_CONF_LOCK
*5 = eCMD_CONF_UNLOCK
Caution!
Some commands are mutually exclusive. They can be enabled only if the
alternatives are disabled. See “Detailed Information for Specific Touchtone
Features” for discussions of these commands.