Filter
Top Products
ReadiVoice Administration & Maintenance Guide
126 Proprietary & Confidential
3 As user cnow, open the
ive.ini
file for editing and find this section near
the end:
4 Change the value after the
WRAnnounceDefault
keyword from
1
to
0
.
Then, save and close the
ive.ini
file.
5 Reboot the bridges so that they read the updated
ive.ini
file and load
the new
.wav
files.
Especially for InnoVox 4000 bridges, it’s important to wait until a bridge
finishes booting before rebooting the next bridge.
Configuring Dial-Out Billing
The dial-out billing feature (also known as unattended dial-out, or UDO,
billing) facilitates billing when subscribers dial out to additional participants
without operator assistance.
With this feature enabled, you can have the ReadiVoice system append (or
prepend) one or more identifying strings of DTMF digits to the dialed phone
number when a subscriber dials out from a conference. The switch that
receives the dial-out must be configured to recognize, strip off, and properly
process these digits for billing purposes.
To enable dial-out billing:
1 Determine the format of the dial-out string that your switch will expect
and recognize.
You can define two additional DTMF strings for each subscriber, and
either or both can be outpulsed before or after the dialed number. You can
define pauses, if necessary, between the dialed number and the prepended
or appended digits. The total length of the string or strings to be
appended/prepended is limited to 24 DTMF digits.
2 Determine how and where these identifier numbers will be stored for
each subscriber.
The subscriber record provides two fields specifically for this purpose,
DialOutPreFix
and
DialOutPostFix
. You can use either or both.
[MiscConfig]
WRAnnounceDefault = 1
Caution!
Perform the following procedure after operational hours.